New

Renewable energy are energy resources that can be replaced rapidly by natural means.

The natural potential energy within the ground, air or wood can be harnessed by innovative

products to produce hot water for domestic, commercial or industrial needs.  Manufactured in

Sweden and in main stream use in European countries, these products help the environment while

eliminating the escalating running costs associated with fossil fuels.

Wood pellet boiler, 15 kW, for domestic hot water or hydronic heating.

Wood pellet/wood chip boilers - hot water boilers fired by wood pellets, wood chip or small

wood briquette. Ranging up to 3 MW capacity.  Complete with flue gas cleaing equipment

and PLC controls.

Heat pumps - Air or ground source heat pumps for domestic and light commercial needs.

New air/water heat pumps up to 25 kW  feature enhance vapour injection (EVI) for superior

performance , and environmetnally friendly refrigerant. 

Contact us if you would to know more about our renewable energy heating solutions.

The Delta Hybrid is a unique combination of the Aerzen rotary lobe blowers and the Aerzen screw compressors.The Delta Hybrid is a groundbreaking design which offers Highest Energy efficiency and reduction in Life Cycle Costs.

The Delta Hybrid provides a differential capability of up to 1.5 bar. The Vacuum operation can now be extended to -700mbar. The operating temperature can now operate safely at a discharge temperature of 160 to 180 degrees C.

The Delta Hybrid has twelve (12) sizes for overpressure and eight (8) sizes for the vacuum.

The Introduction of the New AS 300 AERtronic  Control has created a universal control that can be used on the VM / VML Compressors and the Blowers.

The many features of the AS 300 can be found in the brochure on our website.

The AS 300 Control can also be retro-fitted to existing equipment providing for optimized control and monitoring of the system.

The Centrifugal Fan range available from our manufacture provide a variety of Arrangements and Impellor types, which can be seen by selection within this section.

Volume up to 1000m3/s with differential pressures up to 30kPa are possible.

With the largest in-house testing and balancing facility within the Southern Hemisphere, our clients can be assured that the product will exceed the relevant standards as detailed below. 

Products conform to AS2936, BS848 and US Air Movement and Control association Inc. AMCA310 and AMCA310 performance requirements.

We can also provide replacement impellors of any type with the minimum amount of information.

EnviroGear® combines the durability and reliability that’s needed for pumps operating with any kind of liquid, regardless of viscosity, with the value of reduced maintenance, reduced downtime and reduced environmental costs that users demand. EnviroGear protects both the environment and those that work with it by minimizing leakage. This makes EnviroGear the single-best pumping solution for a wide variety of fluid transfer needs.